Sakai SW300 Operating & Maintenance Instructions page 67

I
3. PERIODICAL MAINTENANCE
6) Brake disk
Take out brake shim (014), separate plate (013) and
friction plate (012). For easy removal, use a piece of
wire which is bent at its end.
Removing 4 or 5 of separate plates (013) and
friction plates (012) respectively, will allow you to
remove brake shaft (004). Take out all of the
separate plates (013) and friction plates (012).
Item Quantity
Brake shim
AIR
Separate plate 15
Friction plate 14
A
CAUTION
Use care not lose steel ball and brake shaft spring.
CV
Reassembly
1) Brake disk
Install brake shaft (004).
Install separate plate (013) and friction plate (012)
alternately. Use care to keep proper quantity and
order of installation.
Separate plate
Brake shaft
A
CAUTION - - - - - - - - - - - - - - - - - - - - - ­
Install the brake shaft all the way to the back end.
<Proper condition> <Fallen off the spline>
I
Installing the brake plate with the brake shaft
remaining at halfway, may cause friction plate
falling off the spline.
-61­