Optimum OPTidrill DH 24BV Operating Manual page 9

1.3 Intended use
WARNING!
In the event of improper use, the drilling machine
will endanger personnel,

will endanger the machine and other material property of the operating company,

the correct function of the drilling machine may be affected.
The drilling machine is designed and manufactured to be used in a non-explosive environment.
The drilling machine is designed and manufactured for holes in cold metals or other non flam-
mable materials or that not constitute a health hazard using a rotating filing-stripping tool that
has a number of grooves for collecting the filings.
If the drilling machine is used in any way other than described above, modified without the
approval of the company Optimum Maschinen Germany GmbH, then the drilling machine is
being used improperly.
We will not be held liable for any damages resulting from any operation which is not in accord-
ance with the intended use.
We expressly point out that the guarantee or CE conformity will expire due to any constructive
technical or procedural changes which had not been performed by the company Optimum
Maschinen Germany GmbH.
It is also part of intended use that you
observe the limits of the drilling machine,

the operating manual is observed,

the inspection and maintenance instructions are observed.


"Technical data" on page 19
WARNING!
Extremely severe injuries.
It is forbidden to make any modifications or alternations to the operation values of the
drilling machine! They could endanger the personnel and cause damage to the drilling
machine.
1.4 Reasonably foreseeable misuses
Any other use other than that specified under "Intended use" or any use beyond the described
use shall be deemed as non-intended use and is not permissible.
Any other use has to be discussed with the manufacturer.
It is only allowed to process metal, cold and non-inflammable materials with the drilling
machine.
In order to avoid misuse, it is necessary to read and understand the operating instructions
before first commissioning.
Operators must be qualified.
1.4.1 Avoiding misuse

Use of suitable cutting tools.

Adapting the speed adjustment and feed to the material and workpiece.

Clamp workpieces firmly and vibration-free.
ATTENTION!
The workpiece is always to be fixed by a machine vice, jaw chuck or by another
appropriate clamping tool such as for the clamping claws.
Safety
Version 1.1.0 dated 2015-02-10
DH24BV | DH28BV | DH34BV | DH40BV
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
GB
Page 9