Optimum OPTidrill DH 24BV Operating Manual page 27


Lift the drilling machine carefully from the pallet of the packaging by means of a crane and a
forklift truck.
WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe injuries or even death.
3.4 Installation and assembly
3.4.1 Requirements regarding the installation site
Organize the working area around the drilling machine according to the local safety regulations.
INFORMATION
In order to attain good functionality and a high processing accuracy as well as a long service life
of the machine, the place of installation should fulfil certain criteria.
Please observe the following points:
The device must only be installed and operated in a dry and well-ventilated place.

Avoid places nearby machines generating chips or dust.

The installation site must be free from vibrations also at a distance of presses, planing

machines, etc.
The substructure must be suitable for machines. Also make sure that the floor has suffi-

cient load bearing capacity and is level.
The ground must be prepared in a way that potential coolants cannot penetrate the floor.

Any parts sticking out such as stops, handles, etc. have to be secured by measures taken

by the customer if necessary in order to avoid endangering persons.
Provide sufficient space for the personnel preparing and operating the machine and trans-

porting the material.
Also make sure the machine is accessible for setting and maintenance works.

Provide for sufficient backlight (Minimum value: 500 lux, measured at the tool tip). At lower

illumination intensities, additional illumination has to be ensured e.g. by means of a sepa-
rate workplace lamp.
INFORMATION
The main switch of the drilling-milling machine must be freely accessible.
3.4.2 Assembly
WARNING!
Danger of crushing and overturning.
The drilling machine must be installed by at least 2 people.
3.5 Installation

Check the horizontal orientation of the base of the drilling machine with a spirit level.

Check that the foundation has sufficient floor-load capacity and rigidity. Place the drilling
machine on the provided underground.

Fix the drilling machine in the provided through-holes on the machine foot.
WARNING!
The condition of the underground and the fixing type of the machine foot to the
underground must be in a way that it can bear the loads of the drilling machine. The
Assembly
Version 1.1.0 vom 2015-02-10
DH24BV | DH28BV | DH34BV | DH40BV
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
DE
Seite 27