Table of Contents
Advertisement
Chapter 7 Using WCDMA/HSPA+ Signal Analyzer
CDP Table
The CDP Table is used to look at a numeric and textual description of all the active code channels in the
signal.
Setting measure setup
After configuring test parameters as described in the "Configuring test parameters" on page 173, you can
continue your measurement. The measurement settings can be saved and recalled as a file. You can also
use JDViewer, PC application software to configure a measure setup, save as a file, and load the file on to
the instrument.
Procedure
Press the MEASURE SETUP hot key.
1
Optional. To set the scramble code, complete the following steps:
2
Toggle the Scramble soft key between Auto and Manual.
Enter a value by using the numeric keys to set manually.
Press the Enter soft key.
Optional. Press the Detect Mode soft key, and then select the signal standard option: WCDMA,
3
HSDPA, or HSPA+. HSDPA is set by default.
To set the S-CCPCH information of the system to be tested, complete the following steps:
4
Press the S-CCPCH soft key.
Toggle the S-CCPCH soft key between On and Off to enable or disable the S-CCPCH.
Press the Spread Factor soft key, and then select the spread factor option: 4, 8, 16, 32, 64,
128, or 256.
Press the Spread Code soft key to set the spread code.
Enter a value by using the numeric keys.
Press the Enter soft key.
To set the PICH information of the system to be tested, complete the following steps:
5
Press the PICH soft key.
Toggle the PICH soft key between On and Off to enable or disable the PICH.
Press the Spread Factor soft key, and then select the spread factor option: 4, 8, 16, 32, 64,
128, or 256.
Press the Spread Code soft key to set the spread code.
Enter a value by using the numeric keys.
Press the Enter soft key.
Optional. To set the threshold, complete the following steps:
6
Press the Threshold soft key.
Enter a value by using the numeric keys.
Press the Enter soft key.
196
JD700B Series User's Guide
Advertisement
Table of Contents
