Table of Contents
Advertisement
Installation and programming manual
Up to 200 actions can be programmed to activate in response to
remote GSM commands.
Each of the actions can be triggered by either an SMS command or a
Caller ID command or both.
Users who wish to activate a command via SMS text must enter the
command details as follows:
where:
•
<xxxxxx> stands for the user PIN
•
a blank space must be keyed in after PIN entry
•
<SMS
text>
programmed via software
The following commands are predefined at default:
•
"CODE" for the change of the user PIN code via SMS message;
the message text format must be:
<old PIN code> CODE <new PIN code>
•
"CREDIT" for balance enquiries relating to the SIM card of the
device; the user will receive an SMS text indicating the
remaining credit.
•
"STATUS"
for
SmartLinkAdv; the user will receive an SMS text indicating:
•• device name and firmware revision
•• GSM network provider
•• GSM signal reception level
•• Presence of the PSTN line
•• list of faults present
•• device tamper status
•• power supply of the circuit
•• armed/disarmed status of the SmartLinkAdv
•• list of zones in alarm status
•• list of terminals in tamper status
•• status of outputs
•• remaining credit as last read
•
"CONNECT" for the maintenance request; the message text
format must be:
<xxxxxx> CONNECT <Connection Name> <URL>:<Port>
where:
•• <xxxxxx> is the installer code PIN, followed by a blank space
•• "CONNECT" is the connection command, followed by a space
•• <Connection Name> is the description of the connection
followed by a space
•• <URL>: is the IP address of the server you wish to connect
to, followed by ":"
•• <Port> is the connection port
The latter two parameters can be omitted if they have
already been included in the GPRS section programming
fields of the SmartLinkAdv.
SmartLinkAdv functions
Commands over the
<xxxxxx> <SMS Text>
is
the
identification
enquiries
relating
GSM network
of
the
command,
to
the
status
of
3-6-1
COMMAND VIA SMS
MESSAGE
as
DEFAULT COMMANDS
the
15
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SmartLink Advanced Series and is the answer not in the manual?