Command And Shortcuts; Remote Activation - INIM SmartLink Advanced Series Installation And Programming Manual

A command is a request from the end-user or a device to the
SmartLinkAdv to carry out one or more of its functions.
During the programming phase of the SmartLinkAdv you can
arrange the commands into shortcuts. A shortcut is a single request
that activates a series of successive functions. If necessary, you can
define the shortcut parameter, in other words, the object of the
shortcut (e.g. define a specific output for functions such as "activate
output" shortcuts).
description
Arm/Disarm
Stop alarms
Delete memory
Clear call queue
Output activation
Output
deactivation
Voice info
Status enquiry
Credit enquiry
GPRS Client
All the functions of the SmartLinkAdv device can be activated from
remote locations.
Therefore, it is possible to send commands to the SmartLinkAdv by
means of:
• SMS messages
• telephone calls using Caller ID
• telephone calls assisted by a voice guide ("Answerphone"
function)
After receiving one of the above-mentioned commands, the
SmartLinkAdv will activate the associated actions.
Both commands and their associated actions can be configured
through the SmartLeague software program, in the sections relative
to the GSM network commands and user codes.
14

Command and Shortcuts

Table 3-1:
function
Applies a preset scenario
Deactivates instantly the outputs activated
by alarm and tamper events
Carries out a "Stop alarms" operation and,
at the same time, deletes alarm and
tamper memories.
Cancels the call queue and stops ongoing
calls (if any).
Activates one of the programmed outputs
Deactivates one of the programmed
outputs
Starts playback of the audible message
playback that informs the user of the
device status
Activates a device status enquiry; the user
will receive one or more SMS messages
containing a list of the parameter values
relating to the status.
Activates balance enquiries relating to the
SIM card of the device; the user will receive
an SMS text indicating the remaining
credit.
Activates the GPRS connection with the
SmartLeague software program via SMS

Remote activation

Available shortcuts
parameter
which scenario
which output
which output
Telephone dialler
3-5
SHORTCUTS
note
Shortcuts are available only
when the SmartLinkAdv is
programmed as an intrusion
control panel
Shortcuts available for codes
only
Refer to the default
commands described in
paragraph 3-6 Remote
activation
3-6
SmartLinkAdv functions