Grizzly G0925 Owner's Manual page 3

7. Remove (2) M10-1.5 hex nuts, (1) M6-1 hex
nut and (1) 6mm flat washer from depth rod.
8. Pull bottom of chuck guard forward to open
and attach depth rod to guard with M6-1 hex
nut and 6mm flat washer (see Figure 5).
Hex Nut
Figure 5. Attaching depth rod to chuck guard.
9. Close guard and insert depth rod through
mounting hole until guard fits around drill
press quill (see Figure 6).
Figure 6. Inserting depth rod through mounting
hole.
Model G0925 (Mfd. Since 2/20)
Washer
Depth Rod
Mounting Hole
Quill
10. With chuck guard around quill, tighten Phillips
head screw and hex nut until guard is snug
(see Figure 7).
Figure 7. Attaching chuck guard to quill.
11. Thread (2) M10-1.5 hex nuts from Step 7
onto depth rod, and snap on pointer so it
points at zero (see Figure 8).
Hex Nuts
Figure 8. Attaching pointer to depth rod.
12. Open chuck guard.
13. Use acetone or lacquer thinner to clean
spindle and chuck mating surfaces.
14. Retract chuck jaws completely.
Pointer
-3-