Table of Contents
Advertisement
SECTION 4: OPERATIONS
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and a face shield when operating
this machine.
Keep hair, clothing, and
jewelry away from mov-
ing parts at all times.
Entanglement can result
in death, amputation, or
severe crushing injuries!
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
-18-
manual
BEFORE
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To complete a typical operation, the operator
does the following:
1.
Examines workpiece to make sure it is suit-
able for drilling.
2.
Puts on required safety glasses and face
shield.
3.
Firmly secures workpiece to table using a
vise or T-slot clamps.
4.
Installs correct drill bit for operation.
5.
Adjusts table to correct height, then locks it in
place.
6.
Selects appropriate spindle speed accord-
ing to drill bit speed chart located on Page
19 and adjusts drive belt to required pulley
sheaves.
7.
Connects machine to power, and turns
machine ON.
8.
Performs drilling operation.
9.
When finished, turns machine OFF and dis-
connects it from power.
Model G0925 (Mfd. Since 02/20)
Advertisement
Table of Contents
