Run The Pingme.c Sample Program; Running More Sample Programs With Direct Connect - Rabbit RabbitCore RCM3209 User Manual

6.5 Run the PINGME.C Sample Program

Connect a Cat. 5 Ethernet cable from your computer's Ethernet port to the RCM3209
board's RJ-45 Ethernet connector. Open this sample program from the
folder, compile the program, and start it running under Dynamic C. When the pro-
ICMP
gram starts running, the green
indicate an Ethernet connection is made. (Note: If the
you are using a hub, check that the power is not off on the hub.)
The next step is to ping the board from your PC. This can be done by bringing up the MS-
DOS window and running the pingme program:
ping 10.10.6.100
or by
Start > Run
and typing the entry
ping 10.10.6.100
Notice that the green
ing place, and indicates the transfer of data. The ping routine will ping the board four
times and write a summary message on the screen describing the operation.

6.6 Running More Sample Programs With Direct Connect

The sample programs discussed here are in the Dynamic C
folder.
—This program demonstrates a basic controller running a Web page.
•
BROWSELED.C
Two "LEDs" are created on the Web page, and two buttons on the Prototyping Board
then toggle them. Users can change the state of the lights from the Web browser. The
LEDs on the Prototyping Board match the ones on the Web page. As long as you have
not modified the
TCPCONFIG 1
address in your Web browser to bring up the Web page served by the sample program.
http://10.10.6.100.
Otherwise use the TCP/IP settings you entered in the
—This program demonstrates a basic client that will send a packet and
•
ECHOCLIENT.C
wait for the connected server to echo it back. After every number of sends and receives,
transfer times are shown in the
Use
ECHO_SERVER.C
—This program demonstrates a basic server that will echo back any
•
ECHOSERVER.C
data sent from a connected client.
Use
ECHO_CLIENT.C
—This program demonstrates Ethernet communication between two
•
ENET_AD.C
single-board computers. The program sends an A/D voltage value to the second single-
board computer via Ethernet for display.
Use
ENET_MENU.C
50
LED on the RCM3209 board should be on to
LNK/ACT
LED flashes on the RCM3209 board while the ping is tak-
LNK/ACT
macro in the sample program, enter the following server
window.
STDIO
to program a server controller.
to program a client controller.
to program the other single-board computer.
SAMPLES\TCPIP\
LED does not light, and
LNK/ACT
SAMPLES\RCM3209\TCPIP\
TCP_CONFIG.LIB
RabbitCore RCM3209/RCM3229
library.