Table of Contents
Advertisement
User Controlled
Start Record on
Power-up
Scheduled
Receive IP Address
Recorder File Name
File Start Time
Data Recorded
File in Progress
FTP Status
File in Progress
Last Completed File
VBStar FTP File Transfer
Configuration: FTP File Transfer > Servers
Up to eight servers are available and can be simultaneously selected. When more than one
server is enabled, the appliance will transfer the newly recorded file to each of the enabled
severs, up to a maximum of eight. Since FTP transfer can be a slower than the recording
process, it is possible to overrun the FTP queue, especially if many servers are enabled. Also,
if operating in Batch record mode and the recorder attempts to open a new file that has not
VBrick MPEG-2 Appliance Admin Guide
The user controls which files to record and send to which
configured server.
When the appliance is powered up, the recorder will automatically
start.
The files will start recording at the scheduled time.
The address of the video source. If unicast, this is the same as the
sender's source IP address.
File name to be recorded.
Starting time of the recording.
Reports the number of bytes currently recorded.
Name of the file currently being recorded.
The status of the Hard Drive FTP send. Values can be:
Transfer in Progress
Idle
Invalid FTP Server
Invalid User Name
Invalid User Password
Local File Open Error
Socket Open Failure
Transfer Failure
Socket Quit Failure
Name of the file currently being sent to the FTP destination
server(s).
• Last Complete FTP File – Name of the last completed file sent
via FTP.
• Operation Functions Buttons:
• Start Recorder – Starts recording selected file (s) to the Hard
Drive destination.
• Stop Recorder – Stops recording selected file (s).
• FTP Auto Send – FTP last recorded file via enabled servers.
• Refresh – Refreshes the content of this screen.
The name of the last completed file. In a batch file, this is the last
indexed file completed.
VBStar
111
Advertisement
Table of Contents
