Table of Contents
Advertisement
Diagnostics
Topics in this chapter
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 79
Diagnostics: Network Tests . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 79
Diagnostics: Device Test . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 83
Diagnostics: Decoder Color Bars . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 84
Diagnostics: Hard Drive . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85
Overview
There are two groups of diagnostics: Low Level Hardware Diagnostics and User Diagnostics.
Low Level diagnostics are run in
mode. (The
Configured Operational Mode
You must be in
Diagnostics
Tests. You can run all other tests from
Note Since running in
the appliance to the
operational state.
To change between normal
1. Log in with Administrator or Operator Privilege. The default login Username and
Password is
2. Go to the
Configuration: System
3. Click
Begin Edit
4. Set
Configured Operational Mode
5. Click
Apply Changes
6. The VBrick will then automatically save the changes and reset.
User Diagnostics
There are four user diagnostics: Network Test, Device Test, Decoder Color Bar, and Hard
Drive.
Diagnostics: Network Tests
Diagnostics: Network Tests > Ping Test
This menu allows the user to initiate a data test from one VBrick to another. To Ping another
VBrick, it's necessary to enter Edit mode. Enter the IP address and Test Settings and select
the
button. The Operational State will read
Start
the
button to display the results of the test. The results of the test will be displayed in
Refresh
VBrick MPEG-2 Appliance Admin Guide
Diagnostics
mode to run Hard Drive Check Disk and Device Test POST
Run
mode interrupts the passing of video, be sure to return
Diagnostics
mode in order to return the appliance to its normal
Run
mode and
Run
/
or
admin
admin
operator
screen.
.
as required.
.
mode. User diagnostics are run in normal
is set in Configuration: System as described below.)
mode.
mode
Diagnostics
/
(case sensitive).
operator
. After the test is completed, use
Ping Test
Chapter 5
Run
79
Advertisement
Table of Contents
