Table of Contents
Advertisement
Recorder Source
Recorder Schedule
Record Duration
Batch Enable
Batch Duration
Batch Wrap Point
Auto FTP after
Record
New File on Channel
Change
OSD Recorder
Indicators
FTP Server Enable
1 to 8 servers are available for FTP. The parameters for these servers are set in the
Configuration: FTP File Transfer > Server menu screen of IWS. When more than one server
is enabled, the appliance will transfer the newly recorded file to each of the enabled severs, up
to a maximum of eight.
Since FTP transfer can be a slower process than the recording process, it is possible to
overrun the FTP queue, especially if many servers are enabled. Also, if operating in Batch
record mode and the recorder attempts to open a new file that has not been completely
transferred, the recorder will stop. The Failure condition is noted in the Recorder Status
menu.
Configuration: Recorder > Network
The Network configuration tab is only displayed if you select
on the previous Configuration: Recorder > General page.
108
Defines the source of video for record. When Dedicated is selected
as the Recorder source, the Network option screen appears as a
selection. The Network selections allow the user to set parameters
necessary to record video from a particular Receive IP address and
Port. If a slot is selected as the Recorder Source, the Network screen
does not appear and whatever video is being received by the
designated decoder is recorded.
• Dedicated – Indicates that the settings are read from the VBStar
settings on the Configuration: Recorder > Network page is IWS.
• Decoder Slot # – Indicates that the settings are set for a specific
Decoder Network Configuration. When a Slot # is specified, the
Network option does not appear since it has no affect.
Specify the begin date and time for the archive in
format (with
in 24-hour format).
hh:mm
The length in seconds of the entire recording session, or
Continuous.
Disabled or Enabled. If enabled, the recorder will create a series of
files and the files will be numbered incrementally.
The length of each batch file in seconds or Maximum. The
minimum length is 30 seconds.
Sets the number of batch files (1–999) that will be recorded before
"wrapping over" the previously recorded files (from lowest to
highest batch number).
Disabled or Enabled. If enabled, the file is automatically FTPed
when the recorded file is completed.
Determines whether or not the Hard Drive starts a new file upon
channel change while recording.
Selecting will show indictors that will appear on the attached TV
screen indicating a record session is in progress. This is a decoder
function.
mm/dd/yyyy hh:mm
for
Dedicated
Recorder Source
© 2009 VBrick Systems, Inc.
Advertisement
Table of Contents
