Table of Contents
Advertisement
validates the data pattern. In this mode the following steps are recommended. No timed or
continuous option is available for this test mode.
•
Turn on transmit
•
Turn on receive
•
Turn off receive
•
Turn off transmit
Diagnostics: Device Test
This screen shows the results of the Power-On Self Test, which is automatically run when the
VBrick is reset or powered on. Other than that, running this test allows the operator to test
the hardware integrity of the VBrick appliance board by running the test one or more times
or by setting the test for continuous operation or for a certain number of test loops. This test
is not often used. It is necessary to be in Diagnostic mode before running these tests. Enter
Diagnostic mode from the
mode after the tests are run. You must be in
Results include
Pass
test sequence may take 5-15 seconds per test sequence; a high intensity test sequence can take
5-15 minutes or more.
VBrick MPEG-2 Appliance Admin Guide
Configuration > System
,
,
. Note that depending on the model, a low intensity
Fail
Not Present
screen. Don't forget to return to
mode before you can run this test. Test
Edit
Diagnostics
Run
83
Advertisement
Table of Contents
