Prevac MG14 Operating Manual page 37

MG14 operating manual Rev 1.4
4.2.8.1 Setting the channel name menu – Group Name
For each channel individual name can be set. This name displays in any menu where corresponding
channel appears.
4.2.9.1 Loading and saving parameters menu – Save & Load
This menu should be used when following actions are required:
Save setting – storage all individual settings which has been set in each menu
Load settings – restore parameters storage in EEPROM memory
Load default – restore original manufacturer parameters
Using the narrow buttons ▲or▼ and MENU/ENTER button you can chose an option.
IMPORTANT!
Storied values are available even after power off.
4.2.10.1 Display parameters menu – Display param.
LCD display is controlled by microcontroller and backlight of it as well. Because of different angle of
few it is possible to set individual brightness and contrast of LCD display – Fig.4-17.
Using the narrow buttons ▲or▼ and MENU/ENTER button you can change the value of brightness
and contrast from 0..100%.
As an additional option there another Screen Server menu is implemented – Fig.4-18
Activating of this option automatically starts internal time counter ( 15 min. ) counting down. If during
this period no action is taken, display brightness is switched to the minimum ( 5% ) after 15 minutes.
It stays in this condition as long as any button is pressed. Pressing any button once activating
previous brightness set.
Fig. 4-17 Display menu
Fig. 4-18 Display menu – Screen Server
37