Rack Installation - Prevac MG14 Operating Manual

MG14 operating manual Rev 1.4

3.2.3 Rack Installation

The MG14 is designed for installation into a rack according to DIN 41 494 (19", 1 HU).
!
Protection class of the rack.
If the product is installed in a rack, it is likely to lower the protection class of the rack
(protection from foreign bodies and water) e.g. according to the EN 60204-1
regulations for switching cabinets.
Take appropriate measures to restore the required protection class of the rack.
In order to use MG14 in the rack there is necessary to remove four stuck gummy legs. For this purpose
proceed as follows:
1. Switch off the MG14 and disconnect it from mains power
2. Turn the MG14 upside down as shown in Fig. 3-1,
3. Remove ( unstuck ) the four stuck gummy legs
4. Turn the MG14 back to normal orientation and place it on the required location
NOTE:
In order to reduce the strain on the front panel it is recommended to equip the rack chassis
adapter with a guide rail.
1. Insert the MG14 into the rack chassis adapter
2. Fasten the MG14 with the supplied collar screws and plastic sleeves to the rack chassis adapter
DANGER
Fig. 3-1 Unstuck gummy legs from the device
13