Connecting; Back Side Of The Device; Mains Connection - Prevac MG14 Operating Manual

MG14 operating manual Rev 1.4

3.3 Connecting

3.3.1 Back Side of the Device

Fig. 3-4, shows the back side of the MG14.
A Connection for IONIVAC measuring signal, channel 1
B Ground screw
C Connection for transmitter, channel 1
D Connection for transmitter, channel 2
E RELAY connection
F AnybusCC connection module
G

Mains connection

H I/O interface
!
Screw for internal protective conductor.
The internal protective conductor is connected to the casing with a screw.
Do not turn or loosen this screw.
The configuration of the available connections is described in the following sections.
3.3.2 Mains Connection
The mains connection (Fig. 3-4, item G) is designed for a mains cable which contains a European
appliance connector on the device side. A mains cable is supplied with the device. If the plug is not
compatible with your wall socket, you have to get a suitable mains cable:

Three-conductor cable with protective ground

Conductor cross-section 3x1.5 mm
Fig. 3-4 Back side of the MG14
DANGER
2
or larger
16