Control Buttons; Menus - Prevac MG14 Operating Manual

MG14 operating manual Rev 1.4
4.1.2 Channels display
MG14 controller can be used to control two transmitters – two channels. Channel no1 is assigned to
Ionization Gauge and can not be changed. For this channel only IONIVAC gauges parameters can
be set – refer to chapter 4.2.4.2.
Channel 2 is an selectable input. As an standard most of OERLICON/LEYBOLD transmitters are
selectable. Set correct transmitter – see chapter 4.2.4.8.

4.1.3 Control Buttons

USER INTERFACE BUTTONS:

4.2.1 Menus

To get into main menu push the ENTER/MENU button once. To move between each menu use
narrow buttons ▲or▼. To get into deeper corresponding menu level push ENTER/MENU button
again. Any time current operation can be canceled by pressing ESC button. The same user come
back one menu level backward .
Fig. 4-2 shows the MENU tree of the MG14 .
Buttons used for user interface related to the alphanumeric
display
EMIS – initialization of ion gauge emission
Up, Down buttons – move between the options
ESCape button – back to previous option or cancel from the
current operation
MENU/ENTER – this button has double meaning:
a) get into the Main Menu mode
b) choice acceptation if it is requested
24