Status Indicator Pir 7000 / 7200 - Dräger PIR 7000 Technical Handbook

Status Indicator PIR 7000 / 7200

(Part no. 68 11 625 / 68 11 920)
Intended use:
The status indicator contains light-conducting components for transmitting light signals to the
outer edge of the status indicator.
The gas transmitter features two status lights and provides the following information:
— Continuous green for indicating operational readiness
— Continuous yellow for displaying a fault or a warning
— Continuous yellow for displaying an error or a warning.
These light signals are arranged on two opposing sides of the status display.
The positioning of the light signals in relation to the upper side/underside of the gas
transmitter may change dependent on how the gas transmitter is mounted. Basically, the
colour assignment (yellow/green) is decisive, not the position of the light signals on the
status indicator.
Dräger Safety recommends that the labels (Power/Fault) are affixed in a such a way that the
outlet areas of the light signals are identified unambiguously.
Mounting:
For mounting on a gas transmitter with
mounting set PIR 7000 (part no. 6811648):
Clean sealing surfaces on the gas
transmitter, if required. Always allow the
sealing surfaces and the base of the
measuring cuvette to dry completely.
Place the two parts of the status display
on the gas transmitter and connect
together.
Make sure that no seals are jammed.
Tighten the two screws.
For mounting on a gas transmitter without
mounting set PIR 7000:
Mount the joint ring PIR 7000 (included
with the status indicator) before mounting
the status indicator.
NOTICE
Accessories
31