Instructions; Prior To Operation; Storage And Transfer - Kessel SECOH SLL Series Instruction Manual

2. Instructions

Prior to operation, read "Instructions" to ensure that the air pump is put in
operation correctly.
Be sure follow the instructions herein described, especially, the following safety
instructions. Each time after reading this Manual, keep it in a designated place so
that the user has access to it at any time.
WARNING

2.1. Prior To Operation

This air pump is designed only for air feeding! Since the fluid flow
runs through the part charged, inflow of any flammable gas or liquid
could cause ignition or an electric shock or short-circuit.
Check the nameplate attached to the air pump body! And be sure to use the
air pump with the specified power supply only. Use of any power supply other
than specified can cause some troubles, including electric shock and short-circuit.
This air pump is not designed do be mounted on a
vehicle. So, do not install it on the vehicle.

2.2. Storage And Transfer

When transferring the air pump, carry the body with both
hands. Do not carry the air pump by holding the filter cover
as the body may slip off the filter cover, the pump may drop
on your feet. Do not carry the air pump by holding the power
cord, it will cut the wires in it. It may cause heat or ignition.
Wear gloves not to be burnt. The body is heating up during
operation.
Do not store the air pump in a place where the ambient
temperature is below –10°C. The magnet inside the air pump
will be weakened and as for the result, the equipment will not
perform as intended.
2. Instructions
High potential risks resulting from improper handling, as it
can cause death or serious injures.
CAUTION
CAUTION
28