Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for SIIG AV-GM01Q3-S1
Summary of Contents for SIIG AV-GM01Q3-S1
- Page 1 Dual-View Universal Video to DVI-I Scaler P/N: AV-GM01Q3-S1...
-
Page 2: Table Of Contents
However, like all electronic equipments, the AV-GM01Q3-S1 should be used with care. Please read and follow the safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit. -
Page 3: Introduction
S-Video, can be further improved. The wide range video support in both input and output can be up to WUXGA or 1080p. AV-GM01Q3-S1 is designed to ease the conversion among the available video formats with affordable cost. With AV-GM01Q3-S1, the bothersome video format issues will not become a bottleneck in your applications. -
Page 4: Specifications
SPECIFICATIONS Model Name AV-GM01Q3-S1 Technical Role of usage Video scaling & format converter HDMI & HDCP HDMI & HDCP 1.1 Compliance Digital video bandwidth 4.95 Gbps Analog video bandwidth 165 MHz Maximum resolution 1080p60 / 1920x1200@60 Input TMDS signal 1.2 Volts [peak-to-peak]... -
Page 5: Ir Remote Control
Relative humidity 20~90% RH [no condensation] IR REMOTE CONTROL PIP/PAP Menu Freeze Video Sleep ON Menu Control Buttons Menu On Exit OSD Source: Sequential source switch Info: Display input type and time Auto: Auto adjustment for VGA input C.C.:No use in this model HDMI:No use in this model TV: No use in this model Aspect: Aspect ratio change... - Page 6 The buttons not listed above are not in use for this model.
-
Page 7: Panel Descriptions
PANEL DESCRIPTIONS Front Panel IR: IR sensor DVI: DVI & VGA output RS-232: Firmware update and future software control Rear Panel Power: +5V DV latch-locking PS2: S-Video/Composite input DVI: HDMI/DVI/Component/VGA input LED: Indicates power up, idle, no signal DIP Switch Switch Position OFF[]–OFF[] ON[]–ON[]... -
Page 8: Hardware Installation
1. Power up the AV-GM01Q3-S1. 2. To reset AV-GM01Q3-S1 back to the factory default values, pull up-and-down the DIP switch 1 & 2 from OFF to ON to complete the process. You NEED to pull back the DIP switch back to OFF in order to get AV-GM01Q3-S1 work normally. -
Page 9: Ir Control Tree
IR CONTROL TREE... -
Page 13: Software Procedure
SOFTWARE PROCEDURE 1. Setting Select the correct ComPort connected to the device. Push “Scan” to start the automatic scan on each. 2. System IR Simulation Cutting Function Update the status from the device to software. Main Function... - Page 14 3. Display Control Display Mode 4. Firmware Update 1. Press this button first 2. Reboot the device to proceed firmware updating...
-
Page 15: Connection Diagram
CONNECTION DIAGRAM... -
Page 16: Warranty
The SELLER will NOT be liable for direct, indirect, incidental, special, or consequential damages resulting from any defect or omission in this manual, even if advised of the possibility of such damages. Also, the technical information contained herein regarding the AV-GM01Q3-S1 features and specifications is subject to change without further notice...
Need help?
Do you have a question about the AV-GM01Q3-S1 and is the answer not in the manual?
Questions and answers