Prem-I-Air EH1614/EU Manual page 8

Remote Receiving
point
Leave the appliance in an upright position for 3 hours before first use.
Plug the mains lead into a 13 Amp mains socket (unless permanently installed)
If connecting via an extension lead, make sure that the lead is rated at 13 Amps
or more, and that it is fully unwound.
Switch the unit on at the mains socket.
This unit can be operated from the front panel or via the supplied remote control.
The ON/OFF button on the control or panel will turn the unit On or Off.
The Mode button will cycle through the built in
programmes in order;

In the cool mode, the digital display on the unit and control panel will
display the desired temperature (16C - 30C) and the cool mode
indicator light will illuminate. The temperature can be adjusted using the
+/- buttons.

In dry mode the display will be blank but the dehumidifier indicator light
will illuminate.

In fan mode the display will be blank but the fan indicator light will
illuminate.
On the main display there is a Condensate Tank Full Indicator light, if this should
illuminate the unit will bleep 8 times and stop then the light will blink 8 times and
then go off for 3s and repeat. The unit will not restart till the condensate tank has
been emptied.
Conensate Tank Full
Indicator
Cool Mode
Indicator
MODE Button
Digital Display Fan Mode indicator
Dehumidifier Mode
Indicator
+/- Buttons
Page 8
ON/OFF Button