Prem-I-Air EH1614/EU Manual page 4

Installing Exhaust Hose
In normal use the EH1614 will produce hot air from the rear exhaust port, this air
can be vented through an open window or wall vent. Connect the exhaust hose
as follows: expand a small section of the end, and screw into the indoor adaptor
Clockwise
Joint A
Attach the indoor adaptop (Joint A) to the
rear exhaust vent by sliding the adaptor
into the grooves till you hear a click.
Joint C
Joint B
Joint B
Heat
Discharge
Pipe
Locating Post
Slot
If the exhaust is to be vented through an
open window then the fish tail adaptor
(Joint C) should be attached to Joint B by
locating the slot in Joint C with the post on
Joint B and rotating slightly in a clockwise
direction.
Page 4
(Joint A) in a
direction, the side marked
TOP should be
upwards Expand
section of the other end of the
hose, and screw into joint B
again in a
direction..
clockwise
facing
a small
clockwise