Prem-I-Air EH1614/EU Manual page 3

2.3kw 8000 btu/hour
Table of Contents

Advertisement

Drain Pipe Clip
Screw
Drain Port
Attach the drain pipe clip to rear panel of the air conditioner using the screw
provided.
Rubber Plug
Spring Clip
Dran Pipe Clip
Dran Pipe
Drain Port
Firmly attach the drainage pipe to the drain port and secure using the pipe hoop
spring clip provided. The other end of the drainage pipe should be sealed using
the rubber plug which again should be secured using the spring clip. Attach the
drainage pipe to the unit by clipping into the drain pipe clip.
In normal operation the EH1614 tank should only gather a small amount of water
as any condensate water is usually vented off with the hot exhaust air
If you wish the condensate tank, can be permanently connected to the drain. To
do this a long drain tube may be attached to the drain port and ran to a suitable
drain.
EMPTY CONDENSATE TANK
To empty the water tank, switch the unit off by pressing the ON/OFF button, wait
for three minutes then disconnect from the mains supply. Place a drainage pan
underneath the drain pipe (at the bottom, rear of the unit in the centre).Release
the spring clip and withdraw the bung, allow the water to drain into the drainage
pan. Replace the bung and spring clip then reconnect the unit to the mains
supply
Page 3

Advertisement

Table of Contents
loading

Table of Contents