Prem-I-Air EH1230 User Manual
Prem-I-Air EH1230 User Manual

Prem-I-Air EH1230 User Manual

8500btu/h class a portable air conditioner

Advertisement

Quick Links

User Guide
EH1230
EH1230
8500BTU/h Class A
Portable Air Conditioner
• 2 cooling and 2 fan speed settings
• 24-hour timer
• Built-in Dehumidification function
• Adjustable louvre
• Easy to install - no external unit required.
Page 1

Advertisement

Table of Contents
loading

Summary of Contents for Prem-I-Air EH1230

  • Page 1 User Guide EH1230 EH1230 8500BTU/h Class A Portable Air Conditioner • 2 cooling and 2 fan speed settings • 24-hour timer • Built-in Dehumidification function • Adjustable louvre • Easy to install - no external unit required. Page 1...
  • Page 2: Product Safety

    • Cleaning and user maintenance shall not be made by children without supervision. • Place the EH1230 on a firm flat surface Ensure that the air outlet is not obstructed. • Do not place on soft surfaces.
  • Page 3: Installation

    User Guide EH1230 INSTALLATION Install the EH1230 on floor approximately 36cm (14") from a wall. Ensure that the air inlets (on the sides) and the air outlets (on the top) cannot be covered. Expand a small section of the exhaust tube, and screw it clockwise into the it the end of the exhaust port of the unit.
  • Page 4 The air conditioner is for indoor use only. Do not install in direct sunlight (to avoid discolouration of the case). Do not install close to a source of heat. The EH1230 is not suitable if the ambient temperature is below 18°C or above 35°C. Page 4...
  • Page 5 User Guide EH1230 Installing the carbon filter: 1. Remove the filter frame from the unit. 2. Remove the carbon filter from its plastic bag 3. Insert the carbon filter into the back of the unit. 4. Re-fit the filter frame.
  • Page 6: Operation

    User Guide EH1230 OPERATION Switch the unit on at the mains socket, then press ON/OFF button (6). The unit will then start. The display (11) will show the ambient temperature in degrees Celsius. The unit will start in the Automatic mode with the trianglew symbol (7) illuminated.Press TEMP+ (3) or TEMP- (4) to set the desired...
  • Page 7 User Guide EH1230 Manual Override (fan Only): Using the MODE switch (1) it is possible to select "fan-only" mode (press the MODE switch until the fan indicator (9) is illuminated on its own. It is then possible to select the fan speed using the SPEED switch (5).
  • Page 8 User Guide EH1230 Dehumidifying: The EH1230 can be used for dehumidification provided that the ambient temperature is above 19°C. Keep the windows and doors closed to increase the efficiency of the dehumidifying operation. Do not use the exhaust tube. Remove the drain cover and rubber bung, and connect a permanent drain tube to the water outlet.
  • Page 9: Maintenance

    User Guide EH1230 The air vent can be tilted up and down, and moved from side to side using the tab to control the air direction. Using the remote control. The remote control has six buttons. These replicate the operations of the buttons on the main unit.
  • Page 10 User Guide EH1230 needs to be replaced, proceed as follows: • Connect the brown wire to the terminal labelled Earth Fuse (5A) (Green "L". Yellow) • Connect the blue wire to the terminal labelled "N". • Connect the green/yellow wire to the terminal labelled with the earth symbol or "E".
  • Page 11: Fault Finding

    User Guide EH1230 FAULT FINDING • No operation (no LEDs lit on control panel) Press ON/OFF switch to make sure the unit is switched on. Check mains supply. Check fuse in mains plug. If the "water full" indicator is flashing - empty the water.
  • Page 12: Technical Specification

    Dimensions: 305 × 380 × 750mm SERVICE WARRANTY Prem-i-Air guarantees the product free from defects in materials and workmanship for a period of one year. Should this unit be operated under conditions other than those recommended, at voltages other than the voltage indicated on the unit, or any attempts made to service or modify the unit, then the warranty will be rendered void.

Table of Contents