Prem-I-Air Elite EH1460 Instructions For Use Manual

Prem-I-Air Elite EH1460 Instructions For Use Manual

4.4 kw (15000 btu/hour) mobile air conditioner

Advertisement

EH1460
4.4 kW (15000 BTU/hour)
Mobile Air Conditioner
Air Conditioning
Cooling
Dehumidifying
Remote control
3 Fan speeds
LED display panel
24 Hour timer
Page 1

Advertisement

Table of Contents
loading

Summary of Contents for Prem-I-Air Elite EH1460

  • Page 1 EH1460 4.4 kW (15000 BTU/hour) Mobile Air Conditioner Air Conditioning Cooling Dehumidifying Remote control 3 Fan speeds LED display panel 24 Hour timer Page 1...
  • Page 2: Before Use

    IMPORTANT Installer and Users please note: These instructions should be read carefully and left with the user of the product for future reference. BEFORE USE Inspect the product including its cable and plug for any signs of damage. If the product is damaged, DO NOT use it, and contact your supplier immediately.
  • Page 3: Pat Testing

    Keep the hose as straight as possible, avoid dips where the moisture from the exhaust air can condense and fill the tube with water. Do not allow the hose to be crushed. The hose can be expanded up to 1.7 m long, but the shorter it is the more efficiently the appliance will operate.
  • Page 4: Product Safety

    PRODUCT SAFETY • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
  • Page 5 Cooling mode: cools if the room temperature is above the selected temperature.Then use the buttons to select the desired room temperature. When the temperature reaches the desired temperature, the compressor will stop, and the fan will continue to run. Dehumidifying mode: removes humidity, but does not affect room temperature.
  • Page 6: Using The Timer

    If the "WATER FULL" indicator lights, the condensate water tank is full. This should only happen very rarely, as most of the water collected is evaporated and sent down the exhaust air tube. To empty the water, switch the unit off by pressing the ON/OFF button, wait for three minutes, and then disconnect from the mains supply.
  • Page 7: Using The Remote Control

    button). Then, whilst the display is flashing, adjust the time using the buttons for the number of hours' delay before switching on. To cancel the timer, press the TIMER button, and then press it again whilst the screen is flashing. USING THE REMOTE CONTROL The cooling, dehumidifying and fan modes are selected in exactly the same way as using the control panel on the main unit.
  • Page 8: Fault Finding

    Cleaning the filter: The filter is located on the side panel of the appliance. Unclip to remove, then remove dust and dirt using a vacuum cleaner. The filter should be cleaned every two weeks to maintain optimum performance. Using a dry 1"...
  • Page 9: Fault Codes

    The unit is defrosting (this will take a few minutes, and afterwards, it will resume operation) Filter is blocked • Cooling is poor on hot days Too much direct sunshine is heating the room Windows or doors are open allowing hot air into the room A lot of people in the room (each person contributes about 75W of heating) Electrical equipment in the room producing heat...
  • Page 10: Technical Specification

    Refrigerant: R410a (820 g) SERVICE WARRANTY Prem-i-Air guarantees the product free from defects in materials and workmanship for a period of two years. Should this unit be operated under conditions other than those recommended, at voltages other than the voltage indicated on the unit, or any attempts made to service or modify the unit, then the warranty will be rendered void.

Table of Contents