Attach Base to Non-Ikelite Housing with 1/4-20 Threaded Mount
1. Remove the protective backing from the Anti-rotational Pad.
2. Line up the pad hole with the larger non-threaded center base hole
and place the adhesive side down on the base.
3. Line up center base hole with the housing mount hole. If the base is
positioned properly, the Quick Release Buttons will be extending
toward the rear of the housing.
1/4" Nylon Washer
10
Quick Release Button
Protective Backing
(peel off before use)
1/4-20 x 5/8" Screw