Attach Ikelite Sync Cord To The Housing And Strobe - Ikelite 6843.72 Instruction Manual

Attach Ikelite Sync Cord to the Housing and Strobe

The Ikelite Housing and Strobe Bulkheads are designed to accept sync
cords with Ikelite 5 pin connector fittings.
1. Lightly lubricate the Sync Cord O-rings. Use ONLY Ikelite lubricant (supplied
with housing). Other lubricants may cause the o-rings to swell and seal
improperly.
2. Remove Bulkhead Caps from Housing Bulkhead and Strobe Bulkhead.
3. Line up the Sync Cord Pins with the corresponding Bulkhead Receptacles.
Gently insert Sync Cord ends into each Bulkhead. Either Cord End may be
attached to a component. DO NOT force this installation. If the Sync Cord
does not seat properly inside the Bulkhead, then the Pins and Receptacles
are improperly aligned (repeat Step 3).
4. Tighten the Knurled Nuts snugly using your Index finger and thumb. DO
NOT use pliers or other tools to tighten the Knurled Nuts.
- Always remove the Sync Cord from your Housing and Strobe when not in
use and replace the Bulkhead Caps.
Diagram E
Knurled Nut
Sync Cord O-ring
Housing or Strobe
Bulkhead
Sync Cord Pin
Ikelite 5-pin
Sync Cord
Bulkhead Cap
17