Attach Base To Ultracompact Housing With Threaded Mounts - Ikelite 4077.67 Product Instruction Manual

3. Line up the 3/8" tray holes with the housing mounts. If the base is
positioned properly, the Quick Release Buttons will be extending
toward the rear of the housing.
4. Place a shoulder washer in the holes corresponding to the housing
mount holes, with the small end of each washer facing down.
5. With your free hand, insert and rotate the correct screws clockwise
until threaded into the housing mounts. Finish tightening the base
to the housing using a flathead screwdriver. DO NOT overtigthen.

Attach Base to ULTRAcompact Housing with Threaded Mounts

1. Determine the correct thread type for your housing mounts. ALL
white housings use 1/4-20 x 3/8" screws. ALL clear and older
housings use 12-24 x 1/2" screws. 1/4-20 screws will not thread into
a smaller 12-24 size mount.
CAUTION: Using the incorrect screws could damage your housing
mounts.
2. Once the correct screws have been selected, place your Ikelite
ULTRAcompact Housing upside down on a flat surface or on your
lap.
8