Strobe Use And Compatibility; Strobe Compatibility; Ikelite Housing Conversion Circuitry; Attach Ikelite Sync Cord To The Housing And Strobe - Ikelite 6973.03 Instruction Manual

Underwater housing for canon eos m3

Table of Contents

STROBE COMPATIBILITY and CONNECTION

AF35 ........................no

DS50........................yes, above serial number 70000

DS51........................yes

DS125......................yes, above serial number 5000

DS160, DS161 ........yes

DS200......................yes, above serial number 7163

Non-Ikelite ..............yes, manual flash exposure only

This small compact housing has Ikelite designed and patented

Conversion Circuitry built right in. The Conversion Circuitry provides real

TTL flash exposure when used with Ikelite DS series strobes. The

Circuitry is automatically activated once a DS series strobe is attached

to the housing and turned on. Once attached, turn the strobe on first

before turning on the camera. The circuitry cannot be powered up or

used by non-Ikelite strobes.

For MANUAL flash operation: Depress the

times rapidly to switch from TTL to Manual flash mode. To return to TTL

mode, turn the strobe off and on again, and then return the strobe to

TTL operation.

The Ikelite Housing and Strobe Bulkheads are designed to accept sync

cords with Ikelite 5 pin connector fittings.

1. Lightly lubricate the Sync Cord O-rings. Use ONLY Ikelite lubricant

(supplied with housing). Other lubricants may cause the o-rings to swell

and seal improperly.

2. Remove Bulkhead Caps from Housing Bulkhead and Strobe Bulkhead.

Reference Diagram E, Page 16

button 4 consecutive

Table of Contents

Troubleshooting