4. Slide Tray into position over the Spacer and press firmly for a
couple seconds. This will allow the Spacer to cling to the base.
5. With your free hand, slide the 3/8" nylon washers over the Housing
Mounting Bolts and tighten base using both 3/8-16 Hex Jam Nuts.
Finish tightening the base to the housing using a 9/16" open end or
socket wrench. DO NOT overtighten.
Attach Base to Compact Housing with Threaded Mounts
1. Determine the correct thread type for your housing mounts. ALL
white housings use 1/4-20 x 3/8" screws. Most clear and older
housings use 12-24 x 1/2" screws. 1/4-20 screws will not thread into
a smaller 12-24 size mount.
CAUTION: Using the incorrect screws could damage your housing
mounts.
2. Once the correct screws have been selected, place your Ikelite
Compact Housing upside down on a flat surface or on your lap.
1/4" Shoulder Washer
Quick Release Button
1/4-20 x 3/8" Screw
7