Warnings And Safety Notes - RC-Plus PLUS POWER 80 Instruction Manual

WARNINGS AND SAFETY NOTES

These warnings and safety notes are particularly important. Please follow the instructions
for maximum safety; otherwise the charger and the battery can be damaged or at worst
it can cause a fire. Also read the chapter before you begin.
• Never leave the charger unsupervised when it is connected to its power supply.
If any malfunction is found, TERMINATE THE PROCESS IMMEDIATELY and refer to
the operation manual.
• Keep the charger well away from dust, damp, rain, heat, direct sunshine and vibra-
tion. Never drop it.
• The allowable DC input voltage is 11-18V DC.
• The allowable AC input voltage is 110V or 220V AC.
• This charger and the battery should be put on a heat-resistant, non-flammable and
non-conductive surface.
Never place them on a car seat, carpet or similar surface. Keep all flammable volatile
materials away from the operating area.
• Make sure you know the specifications of the battery to be charged or discharged to
ensure it meets the requirements of this charger. If the program is set up incorrectly,
the battery and charger may be damaged.
Fire or explosion can occur due to overcharging. This warranty is not valid for any
damage or subsequent damage arising as a result of a misuse or failure to observe
the procedures outlined in this manual.
• To avoid short circuiting between the charge lead, always connect the charge cable to
the charger first, then connect the battery. Reverse the sequence when disconnecting.
• Never attempt to charge or discharge the following types of batteries:
• A battery pack which consists of different types of cells
(including different manufacturers)
• A battery that is already fully charged or just slightly discharged
• Non-rechargeable batteries (pose an explosion hazard)
• A faulty or damaged battery
• A battery fitted with an integral charge circuit or a protection circuit.
• Batteries installed in a device or which are electrically linked to other components
• Batteries that are not expressly stated by the manufacturer to be suitable for the
currents the charger delivers during the charge process
Please bear in mind the following points before commencing charging
• Did you select the appropriate program suitable for the type of battery you are charging?
• Did you set up appropriate current for charging or discharging?
3