Setting the Linear Security
Sets how many times to scan the same bar code to determine a successful read. The options
are 1 through 4. The default is 1.
Select
To
1
The scanner must scan a bar code once for a successful read.
2
The scanner must scan a bar code twice for a successful read.
3
The scanner must scan a bar code three times for a successful read.
4
The scanner must scan a bar code four times for a successful read.
Setting the Bi-Directional Redundancy
Specifies that good scans must occur in both directions (forward and reverse) for the scan to be
complete. The options are 1 through 4. The default is 1. This is used in conjunction with linear
security.
Select
To
1
The scanner must scan a bar code once for a successful read.
2
The scanner must scan a bar code twice for a successful read.
3
The scanner must scan a bar code three times for a successful read.
4
The scanner must scan a bar code four times for a successful read.
Using Picklist Mode
Allows the scanner to scan only the barcode directly within the beam's crosshairs. This may be
needed when several bar codes appears on a label.
Select
To
Enabled (On)
The scanner scans only the specific barcode directly within the beam's
crosshairs.
Disabled (Off)
The scanner scans any bar code within the field of view.
Classification: Avery Dennison – Public
Configuring the Scanner 3-3