Setting The Supply Position; Setting The Overfeed Distance; Setting The Maximum Supply Length - Avery Dennison Monarch Pathfinder 6059 System Administrator Manual

S e t t i n g t h e S u p p l y P o s i t i o n
Adjust the supply position to set where data prints vertically on the supply. The adjustments are
in steps (0.00333 inch). The default value is 0.
Enter the supply position value. The printing shifts as shown.
Select
+ (positive) value
- (negative) value
S e t t i n g t h e O v e r f e e d D i s t a n c e
Adjust the overfeed distance to set the distance that your supply is fed out of the chute after it
prints. The adjustments are in steps (0.00333 inch). The default value is 0.
Select
Increase the value
Decrease the value
S e t t i n g t h e M a x i m u m S u p p l y L e n g t h
Adjust the Max Supply Length if you are using supply that is longer than 8.0". The size of your
supply is measured from top to bottom. The default value is 8 inches. If your supply is shorter
than 8" you do not need to adjust this setting (the printer automatically detects supply that is 8"
or shorter).
Select To
Increase the Feed more supply out of the chute after printing.
value
Decrease the Feed less supply out of the chute after printing.
value
To
Increase the setting. Moves the printed image down on the label.
Decrease the setting. Moves the printed image up on the label.
To
Feed more supply out of the chute after printing.
Feed less supply out of the chute after printing.
Classification: Avery Dennison – Public
Setting Supply & Printer Options 2-3