Table of Contents
Advertisement
2.5 Completion
Installation Completion
Check the connection of all wires and the RJ-45 plug to the board connector.
Caution
All unused connectors have to have tightened screws in order to avoid
vibration caused by sound.
Nametag Placing
Every intercom package includes a piece of transparent foil, which can be laser
printed. Cut the printed foil and insert the nametags in the buttons.
Nametag dimensions for button:
1 button: 52.0 (W) x 15.2 (H) mm (dimensional tolerance: +0; -0.5 mm)
Caution
The area where nametags are placed is called a wet zone. After heavy
rain, water can penetrate to the nametag. Water in this area does not
affect the intercom functionality in any way and evaporates soon.
Always use waterproof foil (enclosed or other) for the nametags. Never
use paper or ink jet printing to avoid damage due to water leakage!
Nametag inserting/replacing:
Remove the frame.
1.
Lift up the button door. The 5-button module buttons have just one door.
2.
Remove the used nametag and insert a new one.
3.
Close the button door.
4.
Replace the frame.
5.
Frame Replacement
Check the frame sealing before replacing the frame.
Version A
2N TELEKOMUNIKACE a.s., www.2n.cz
56/78
Advertisement
Table of Contents
