Table of Contents
Advertisement
2.3 Electric Installation
This subsection describes how to install the modules, how to connect the 2N
main unit to the power supply and LAN and how to connect other elements.
Caution
The device must be part of the electrical system of the building.
Mounting Preparation
®
Place the
2N
1.
and pull the cables through the bottom holes. Pull the Ethernet cable through
the bottom hole to the left if necessary.
Insert the metal fitting elements up and down and screw the access unit tight.
2.
You can level the unit slightly in this mounting type.
Main Unit
Power Supply Connection
®
2N
IP Solo
can be powered either from an external 12 V / 2 A DC source or directly
from the LAN equipped with PoE 802.3af supporting network elements.
External power supply
Use a 12 V ±15 % SELV supply dimensioned to the minimum current consumption of 2
A (Part No. 91341481E) to make your system work reliably.
2N TELEKOMUNIKACE a.s., www.2n.cz
IP Solo
on the flush mounting box / pre-drilled holes with dowels
®
IP Solo
42/78
Advertisement
Table of Contents
