Mounting The Charger; Mounting On A Flat Surface; Mounting On A Wall - Uniden MHS550 Owner's Manual

Mounting the charger

You can mount the charger on any flat surface or on a wall.

Mounting on a flat surface

1. Use the three holes at the base of
the charger as a template to mark the
drill holes.
2. Using a ⅛ inch (or 3 mm) drill bit, drill
three holes ½ inch (13 mm) deep.
3. Use the provided screws to attach
the charger to the surface.

Mounting on a wall

Before wall-mounting the charger, be sure the wall material is
strong enough to hold the weight of both the radio and
charger. Use anchors appropriate for the wall material.
Use the charger Use the charger
1 1
as a template to as a template to
mark drill holes. mark drill holes.
1. Using the holes in the rear of the charger as a
template, mark the location of the drill holes.
2. Using a ⅛ inch (or 3 mm) drill bit, drill two holes ½ inch
(13 mm) deep. (If you are using anchors, follow the
drilling instructions on the packaging.)
3. Insert the screws into the holes, leaving ⅛ inch (3 mm)
of space between the wall and the screw head.
4. Place the holes on the charger over the screw heads.
Slide the charger down to lock it into place.
20 Uniden MHS550 Radio Owner's Manual
Insert the screws Insert the screws
2 2
(be sure to use a (be sure to use a
proper anchor). proper anchor).
Place the charger Place the charger
3 3
over the screw over the screw
heads and push it heads and push it
down into place. down into place.