Table of Contents
Advertisement
2.
With your other hand, grip the upper part of the tray
and lift the cover open.
3.
Align the batteries' positive and negative terminals with the
drawing on the tray and snap each battery into place.
4.
Insert the two hooks on the lower part of the tray into the
notches on the cover; close the cover. (The cover fits
snugly but you should not have to force it closed.)
5.
Install the alkaline battery tray in your radio just as you do
the Li-Ion Polymer battery (see page E-15).
WARNING! The tray is designed to prevent the accidental charging of alkaline batteries. Never
use alkaline batteries in the radio without the alkaline battery tray. Do not attempt to modify
the battery tray design.
CONNECTING POWER
Plug the AC or DC Power Adapter into the charger through a jack on the bottom of the
charger.
MOUNTING THE CHARGER
Connect power to the charger before mounting the charger into position.
You can mount the charger on any flat surface.
1.
Use the two holes at the base of the charger as a template to mark the drill holes.
2.
Using a 1/8-inch (or 3 mm) drill bit, drill two holes 1/2 inch (13mm) deep.
3.
Use the provided screws to attach the charger to the surface.
NOTE: The charger must be mounted at least 2 feet (24 inches) from the compass to prevent
E-24
magnetic interference with either device.
Uniden MHS335BT Radio Owner's Manual
Insert AC or DC adapter plug
into the adapter jack.
Advertisement
Table of Contents
