Mounting.the.charger; Charging.the.battery - Uniden MHS125 Owner's Manual

note: each time you open the battery case, check the

rubber seal. Make sure the seal is seated in the groove
and there is no dirt or debris on it. if the rubber seal
looks worn or damaged, contact customer service to
order a replacement (see the back cover page for contact
information).
5. Install the alkaline battery case in your radio just as you do
the Li-Ion battery (see page E-13).
Warning! the case is designed to prevent the accidental
charging of alkaline batteries. never use alkaline batteries
in the radio without the battery case. Do not attempt to
modify the battery case design.
Mounting the Charger
You can mount the charger on any flat surface.
1. Use the two holes at the base of the charger
as a template to mark the drill holes.
2. Using a 1/8-inch (or 3 mm) drill bit, drill
two holes 1/2 inch (13mm) deep.
3. Use the provided screws to attach the
charger to the surface.
Charging the Battery
Your radio includes a charger and a
rechargeable battery pack. Place your radio
in the charger with the display facing forward.
Make sure that the CHARGE LED on the
charger turns orange.
Cautions:
Use only the battery and charger

supplied with this radio. Using a different charger or
battery can damage the radio and create a risk of fire or
shock.
Uniden MHS125 Radio Owner's Manual
E-15