Mounting The Charger; Charging The Battery - Uniden MHS135 Owner's Manual

# NOTE: Each time you open the battery case, check the rubber
seal. Make sure the seal is seated in the groove and there
is no dirt or debris on it. If the rubber seal looks worn or
damaged, contact customer service to order a replacement
(see the back cover page for contact information).
5. Install the alkaline battery case in your radio just as you
do the Li-Ion battery (see page E-13).
WARNING! The case is designed to prevent the accidental
charging of alkaline batteries. Never use alkaline batteries in
the radio without the battery case. Do not attempt to modify
the battery case design.

Mounting the Charger

You can mount the charger on any flat surface.
1. Use the two holes at the base of the
charger as a template to mark the
drill holes.
2. Using a 1/8-inch (or 3 mm) drill bit,
drill two holes 1/2 inch (13mm) deep.
3. Use the provided screws to attach the
charger to the surface.

Charging the Battery

Your radio includes a charger and a
rechargeable battery pack. Place your radio
in the charger with the display facing forward.
Make sure that the CHARGE LED on the
charger turns orange.
Cautions:
Use only the battery and charger
x
supplied with this radio. Using a different charger or
battery can damage the radio and create a risk of fire
or shock.
The charger is not waterproof. If the charger falls into
x
Uniden MHS135 Radio Owner's Manual
E-19