Mounting The Charger - Uniden MHS155UV Owner's Manual

Setting up the Hardware
2. Line up the battery's connector with the jack inside the battery
compartment (the connector only fits one way).
3. Push the connector in firmly. Tug on the battery wires gently to make
sure you have a good connection.
4. Seat the battery case in the battery compartment.
5. Before replacing the battery cover, check the rubber seal located
on the under side of the cover; make sure that the seal is set in the
groove and that there is no foreign matter under the seal.
WARNING: The accessory battery tray is designed to
prevent the accidental charging of non-rechageable
batteries. Never use non-rechargeable batteries in the
NOTE
radio without the accessory battery tray.
6. Replace the battery compartment cover. Tighten the screw securely.

Mounting the Charger

You can mount the charger on any flat surface.
1. Use the two holes at the base of the
charger as a template to mark the drill
holes.
2. Using a 3mm (1/8-inch) drill bit, drill
two holes 13mm (1/2 inch) deep.
3. Use the provided screws to attach the
charger to the surface.
UNIDEN MHS155UV
13
UHF CB+VHF Marine Radio