Default Contrast Setting; Character Attributes; Fonts - Bosch Rexroth IndraControl VCP 05 Project Planning Manual

6-2 Bosch Rexroth AG | Electric Drives and Controls
Display and Operating Components
6.1.2

Default Contrast Setting

6.1.3

Character Attributes

6.1.4

Fonts

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
If the contrast setting is such that it is no longer possible to read the
masks, you can use the user mode switch to reset the contrast to the
default value.
For the table with the switch positions of the user mode switch, see
chapter "User Mode Switch".
The switch position for the default contrast is identical with the "Activate
download via hardware". The contrast is reset before a corresponding
message is displayed. The warning will be displayed in a legible man-
ner.
To restore the default contrast:
1. Switch the device off.
2. Set the switches S1 and S4 of the user mode switch to ON.
3. Switch the device on again.
4. When the warning appears, switch the device off again.
5. Set switch S4 to OFF.
6. Then switch the device on again.
The application will not be lost.
The following character attributes can be displayed on the device:
– Normal
– Flashing
You are able to use the font "Normal" and the character set
"Katakana".
Rexroth IndraControl VCP 05 | R911299726 / 02