Advertisement
6. Attach Leg (K) to Top Panel (A) and Bottom Panel (B); insert hanger bolts on Leg (K) into
pre-drilled holes in corner blocks on Top Panel (A) and Bottom Panel (B); make sure the
other end of Lower Front Panel (G) sits in the short slot in Leg (K). Slide a Flat washer (O), a
spring washer (N), and a Hex nut (M) onto each hanger bolt as shown below; loosely tighten
Hex nuts (M) with wrench (L).
7. Slide 2pcs Back Panels (E) into the long slots in Leg (J, K); make sure Back Panels (E) also
sit in slots underneath Top Panel (A) and the side with quarter round notch right below the
last corner of Top Panel (A) as shown below.
4
Advertisement
