pottery barn kids BELDEN CORNER UNIT Manual page 3

4. Insert hanger bolts on Leg (J) through pre-drilled holes in corner blocks on Top panel (A) and
Bottom Panel (B); Make sure the short slot on Leg (J) and slot underneath Bottom Panel (B)
are on same side. Slide a Flat washer (O), a spring washer (N), and a Hex nut (M) onto each
hanger bolt as shown in figure Step 4-1; loosely tighten Hex nuts (M) with wrench (L). Place
a Lower Front Panel (G) into slots underneath Bottom Panel (B) and Leg (J) as shown in
figure Step 4-2.
5. Attach Leg (H) to Top Panel (A) and Bottom Panel (B); insert hanger bolts on Leg (H) into
pre-drilled holes in corner blocks on Top Panel (A) and Bottom Panel (B); make sure the
other end of Lower Front Panel (G) sits in the slot in Leg (H). Slide a Flat washer (O), a
spring washer (N), and a Hex nut (M) onto each hanger bolt as shown in figure Step 5-1;
loosely tighten Hex nuts (M) with wrench (L). Place another Lower Front Panel (G) into the
other slots underneath Bottom Panel (B) and Leg (H) as shown in figure Step 5-2.
3