Related Manuals for pottery barn kids BLYTHE BUNK BED TWIN OVER TWIN
Summary of Contents for pottery barn kids BLYTHE BUNK BED TWIN OVER TWIN
- Page 1 BLYTHE BUNK BED TWIN OVER TWIN www.potterybarnkids.com Date: 2014-Sept.-25 Page 1 of 11 Rev:...
- Page 2 Before each usage or assembly, inspect bunk bed for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use bunk bed if any parts are missing or broken. DO NOT use substitute parts. Contact pottery barn kids for replacement parts and instructional literature if needed.
-
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS: Please read all instructions carefully before assembling. For your safety, assembly by two or more adults is strongly recommended. Keep instructions for future use. Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural integrity of the item. - Page 4 8 x 30mm-56x 1/4” x 1-1/4”-8x TOOLS REQUIRED (Not included): Philips Head Screwdriver ASSEMBLY INSTRUCTION STEPS: 1. Thread the 4 Legs (G) onto the cut-outs located on the bottom legs of (2) Tall End Board (A) until tight, as seen in the illustration below.
- Page 5 2. Attach (2) Side Rails (C) to (2) Tall End Board (A) as shown below. 3. Secure the Side Rail (C) with (8) Long Bolts (J), (8) Spring Washer (L), (8) Half moon Washer (K). Tighten the bolts by Allen Key (I), as shown in the illustration below. 4.
- Page 6 6. Attach the Long Guardrail (D) to the Side Rail (C). Make sure the brackets are facing inwards and sit well on top of the side rail, as seen in the illustration below. 7. Insert (6) Short Screw (P) through the holes on the brackets into Side Rail (C). 8.
- Page 7 10. Fasten the Short Guardrail (E) to the Side Rails (C) by Short Screw (P) inserting through the brackets into the pre-drilled holes on the Side Rails. Make sure there is no gap in between the guardrail end and the Short End Board (B) which is opposite the desired entry point before screwing the parts.
- Page 8 14. Extend and place the Slat Roll (F) to bed frames. Secure the slats by (56) Long Screw (N) with a Phillip Head Screwdriver (not provided). 15. Put the (4) Connecting Bolt (O) into pre-drilled holes on the post top of (2) Tall End Board (A). Make sure the groove at the end of connecting Bolts (O) is facing upwards as seen in the illustration below.
- Page 9 16. Insert (4) Spring Washer (T), (4) Flat Washer (U), (4) Small Bolt (S) through the holes of the posts of Tall End Board (A) and into the bottom holes of the Connecting Bolts (O). 17. Tighten the bolts with Allen Key (I). 18.
- Page 10 22. Place and hold (5) Metal Bracket (M) on the bottom of the guardrails in 5 locations and use (10) Short Screws (P) to secure guardrails and side rails together, as shown below . Date: 2014-Sept.-25 Page 10 of 11 Rev:...
- Page 11 23. Attach the Ladder (H) to the opening of the Short Guardrail and ensure the pre-installed hooks on the ladder sit well on side rail of both upper and lower beds. 24. Insert (4) Short Screw (P) through the holes on the hooks and into the pre-drilled holes on the side rails. 25.