Campbell CELL200 Series Product Manual page 87

4g lte cellular module
Hide thumbs Also See for CELL200 Series:
Table of Contents

Advertisement

set client timeout ###
set client url ###
set comms watch
set div ###
set ipprotocol ###
set listen port ###
set mode ###
set pdp pass ###
set pdp user ###
set power duration ###
set power repeat ###
set power start ###
set ppp pass ###
set ppp user ###
Sets the timeout, in seconds, used by serial client and serial
client/server modes. ### is a number. The accepted range is 1
through 120.
Sets the client URL or TCP/IP address used in serial client and serial
client/server modes. ### is a string.
This command is interactive and allows the user to watch or do a
trace on a specific modem interface. The user selects a number
corresponding with the interface they wish to view.
Sets the modem antenna configuration. ### is a string. Disabled
and Enabled are the only two values that are accepted.
Sets the TCP/IP protocol used by the modem when communicating
with the cellular network. ### is a string. Accepted values are IPv4 ,
IPv6 , and IPv4/IPv6 .
Sets the listening TCP/IP port of the modem for use in serial server
and serial client/server modes. ### is a number. The accepted
range is 1 through 65535.
Sets the modem operating mode. ### is a string. Accepted values
are PPP and Serial Server .
Sets the PDP password. ### is a string.
Sets the PDP username. ### is a string.
Sets the on duration, in minutes. ### is a number. Accepted values
are: 5, 10, 15, 20, 25, 30, 35, 40, 45, 50, 60, 120, 180, 240, 300, 360,
420, 480, 540, 600, 660, 720, 780, 840, 900, 960, 1020, 1080, 1140,
1200, 1260, 1320, 1380, and 1439.
Sets the modem repeat cycle. ### is a number. Accepted values
are: 1441, 15, 20, 30, 40, 50, 60, 120, 180, 240, 300, 360, 420, 480,
540, 600, 660, and 720. A value of 1441 or greater will disable the
repeat cycle.
Sets the modem Start (power-on) Time, in minutes. ### is a
number. Only 15 min increments are accepted (0, 15, 30 to 1440). A
value of 1440 will set the modem to "Always On".
Sets the PPP protocol password. ### is a string.
Sets the PPP protocol username. ### is a string.
CELL200-Series 4G LTE Cellular Module
83

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cell205Cell210Cell215Cell220Cell225

Table of Contents