Part Number 34285
Revision: 07/2020
www.campbellsci.com.au/cellular-communications
1. Introduction
NOTE:
This Quick Deploy Guide is a general reference to give the
installer an overview of the steps required to make this
system operational. The Product Manual is the definitive
source for detailed installation instructions and
information.
For best results, update to the latest data logger
operating system and version of Device Configuration
Utility.
NOTE:
CR3000, CR1000 and CR800-series users must refer to the
CELL200 Product Manual. This Quick Deploy Guide applies
to the CR300, CR1000X and CR6 data loggers. For any
other data loggers, please check the Product Manual or
contact Campbell Scientific.
2. Selecting a data service
Before installing a data logging system with telemetry, you will
need a SIM card and data plan. For most applications, Telstra
will offer the best coverage, especially in regional areas.
Telstra and Optus coverage maps can be found on each
provider's respective websites.
4G LTE Cellular Module
For Private Dynamic IP Addresses
The CELL220 and CR300-CELL220 will work with standard data
plans. No extra steps are necessary because of the
complimentary Konect Pakbus Router service. A micro-SIM
(3FF) is the correct size for use with the CELL220.
3. Install the SIM card
1. Remove the SIM card cover.
2. Note the location of the notched corner for correct
alignment. The gold contact points of the SIM face
down when inserting the SIM card as shown in the
following figure. Gently slide the card into the slot until
it stops and locks into place. To eject the SIM card,
press it in slightly and release.
3. Replace the SIM card cover.
FIGURE 3-1. SIM card installation
4. Konect PakBus Router setup
4.1 Get started
You will need the Konect PakBus Router redemption code that
came on a card with the CELL200 series.
Open a web browser and go to www.konectgds.com.
1