Spin Tack System - Nacra F16 Assembly Manual

1.9 Spin tack system

1. Mount the tack-releaseline. Tie a figure
8 knot on the port side underneath the
trampoline. Attach the ring 4x 25 at the
other end on the starboard side under-
neath the trampoline.
3. After the 16mm block use the grommet
on the starboard side of the trampoline
5. Take the other end of the tackline shock-
cord and use the small grommet in the
middle of the V-bar to exit. Tie a loop in
the shockcord. This loop will be used to
tie onto the middle of the spinsheet.
2.
4.
Note:
The F18 infusion and Carbon 20 has the tackline
guided by a 29mm carbo block attached on the
staymaster.
NACRA EMPOWERING SAILORS SINS 1975
Feed one end of the tackline through the
block located underneath the front cross-
bar next to the mastpin. Then lead the
tackline through the ring, the cleat and the
16mm block next to the cleat.
Tie the tackline shockcord to the end of
the tackline and lead the shockcord
through the grommet on the starboard
side of the trampoline