GRAUPNER GR-18 Series Manual page 14

Suggested throttle course setting
WARNING
!
14 - 24
The motors arm at -95%, for this you need to limit the servo
travel to -94...100%, so that the motors cannot stop during
the flight.
Throttle course
Attitude mode
with limit
Protection function against undesired start of the motors.
Risk of injury by propellers!
Normal mode:
For safety reasons the motors start after the switching on
through the motor stop switch only if in Attitude and in Rate
mode the throttle stick is in the lower position. Move the
throttle stick slowly in the lower position, then it is possible to
control the speed normally.
Only in Acro 3D mode:
In Rate mode the motors start after the switch on through the
motor stop switch only by lower throttle. Only after that the
throttle stick has passed the middle position the motors speed
can be controlled regularly.
Move the throttle stick slowly over the middle so that the
motors do not start uncontrolled fast and the copter flies away
without control.
Install the propellers only as very last operation before flight.
Make practice with this function without propellers before you
install them on the copter..
This safety function will be automatically set off if in the trans-
mitter you program a time delay on the gas channel. Be sure
that in the flight phase switching or in the throttle stick menu
no delay is set.
linear to max.
Min. Thr. 95%
GR-18_3D_jh_V1