Source Audio EQ2 Programmable EQ User Manual page 28

External Switch
Controls for configuring the action of the External Switch. Please note that the hardware options for
the Control Input jack must be set to "External Switch (Assignable)" to use these functions. The
external switch can be assigned to several functions:
•
Disabled – the footswitch will be ignored for this preset
•
Channel Swap – Equalizer settings for Channel 1 and Channel 2 will be "swapped" when the
footswitch is pressed. This function can be used quickly changing the entire equalizer mid-
song for a solo boost or timbre change.
•
Input Select – This option can be used with multiple instrument inputs. By default, Input 1
will be used and Input 2 will be muted. When the footswitch is pressed Input 2 will be used
and Input 1 will be mute. This option is great for switching instruments on the fly.
•
Output Select – when using a single input and multiple outputs, you can effectively use this
option as an "amp switcher". By default, the signal is sent to Output 1 and Output 2 is
muted. When the footswitch is pressed, Output 2 will be unmuted and Output 1 will be
muted.
•
Use for External Control – This powerful feature allows you to use the footswitch as the
primary control source for the External Control section instead of an expression pedal. That
means all of the control options available via expression can be mapped to the external
switch instead! Any combination of level, frequency, Q adjustments, etc. can be configured.
Note that unlike an expression pedal which will change continuously over the range between
Min and Max, the switch will smoothly toggle back and forth between the Min and Max
values
The action of the external switch is also assignable:
•
Momentary – the assigned switch function will only be active while the external switch is
depressed. Once released it will return to the default values.
•
Latching – in Latching mode, the external switch will "latch" when pressed and released
and stay enabled until the switch is pressed again.
External Control
Control up to four parameters with a Source Audio Dual Expression Pedal or Tap Tempo Switch. Use
the dropdown menus in the External Control block to select the expression device (Control Source)
and controlled parameter (Control Option). Use the Min and Max fields to set the depth of the
expression sweep.
Presets
The Presets section is located on the right side of the Neuro Desktop interface. There you will find a
list of all the presets and empty preset positions available in your EQ2. The Presets section is also
where you Save, Import, and Export presets. The buttons located at the top of the Presets field
perform the functions listed below:
SA270 EQ2 User Guide 28