Maintenance - S&P INFRARED-125 Manual

Setting the run-on timer (Only for the INFRARED-155 model)
NB: Before setting the timer, check that the device's electricity supply is completely dis-
connected.
− Remove the front cover with a screwdriver, pressing on the two tabs on the side of the
device (See Fig. 4).
− Following the below table and using a small screwdriver, you can change the sequence
of the two micro-switches on the electronic control board and select the run-on time
as desired:
Position
ON
1 2
ON
1 2
ON
1 2
ON
1 2

5. MAINTENANCE

Before starting any maintenance operation, don't forget to disconnect the device at the mains
and let the heater cool down for a few minutes.
This product requires no specifi c maintenance. It only needs to be cleaned periodically to pre-
vent dust build-up on the lamps, as this could cause the heater to overheat. Clean the lamps
with a brush and the product's body with a damp cloth.
The lamps must be replaced by qualifi ed staff, so contact the S&P Offi cial Service Network,
for expert technical assistance.
Do not submerge the device or spray it with water.
6. PUTTING OUT OF SERVICE AND RECYCLING
EEC legislation and our consideration of future generations mean that we should
always recycle materials where possible; please do not forget to deposit all pac-
kaging in the appropriate recycling bins. If your device is also labeled with this
symbol, please take it to the nearest Waste Management Plant at the end of its
servicable life.
Operation without run-on timer (standard setting)
OFF after 30 minutes
OFF after 60 minutes
OFF after 120 minutes
Timer
15